If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"Insert Windows Installation CD" Hell -- Help, Please!
When it asks for the W98 CD, insert the disk and hit browse to get the
system pointed in the right direction. -- Regards Ron Badour, MS MVP for W98 Tips: http://home.satx.rr.com/badour Knowledge Base Info: http://support.microsoft.com/default.aspx?pr=kbinfo "Exhausted" wrote in message ... OK, so...did I accidentally solve this problem, or what? Either way, someone please explain the outcome! : I've been having trouble getting a USB 2.0 upgrade card installed, but I go through the same problem every time I try to install any new hardware on my Win98SE box that I have to use to support a legacy outboard device. I try to add some new card, but during install it always asks for the Windows installation CD, then it can never find what it's looking for. I've replaced my old Win98SE installation CD, which did show read problems on some CD- ROMs, with a good backup copy from a friend. No difference in outomes. So, I just gave up and ran the setup program supplied with the USB 2.0 upgrade card and rebooted. Win98SE began its "new hardware" dance and asked for the drivers. I referred to the folder on the card's CD where they were located. It found the drivers there, so I pressed next to install -- at which time that %$$)*~@^ "Insert Windows Installation CD" message came up. I tried the new Win98SE installation CD I got from my buddy. No dice. It says it can't find the file it's looking for, some USB- related driver. I press skip file. It says it can't find another file and I press skip file for that, too. I go through this a few times -- each time it finds the driver I need on the card's Win98SE drivers folder on the CD that came with the card and then asks for the WIN98SE installation CD to be inserted, which I ignore -- and reboot. Upon checking Device Manager, I find that there are two yellow- checked devices related to this card & USB. I go through the above routine with them and reboot. Eventually, ALL the devices in Device Manager are installed properly. There are no yellow checks anywhere in Device Manager. The USB 2.0 upgrade card appears to be properly installed and working as it is supposed to. I think. I've rebooted several times and there are no apparent problems. So, someone explain to me what's going on here -- is that blasted "insert Win98SE installation CD" rigmarole actually an OS bug, or what? I went though a similar song & dance with an Ethernet card, but didn't notice as carefully what was going on...but eventually with skipping through the Win98SE installation CD demands, the card was up and running, too. Anyone know what's going on here? As always, thanks for any help! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PCR-- need ref to your update list | jt3 | General | 42 | May 11th 06 06:40 PM |
SCANDISK on 6GB drive producing Errors at 2.09GB to end. | Jerry | Disk Drives | 15 | July 21st 05 07:00 PM |
WINDOWS GURU - DAN GOOKIN | AAH | General | 0 | June 22nd 05 09:37 AM |
can't access .pif | Ron Jacob | General | 13 | September 7th 04 03:23 AM |
Zero-byte D: drive should not show, C: missing from Device Manager | *Vanguard* | General | 8 | June 12th 04 04:19 AM |