If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Setup.MSI
When I try to re-install my printer on my computer, I get
a pop-up box that asks me which program I would like to use to open my set-up.msi program. I have downloaded new drivers from MS and I did a complete re-install of my ME and I am stuck at this point... Any ideas? |
Thread Tools | |
Display Modes | |
|
|