If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Number of switches - 100BaseT
Ethernet timings dictate a maximum (and minimum) cable separation between
nodes. This is also reflected in the number of switches (or hubs) permitted between nodes. I can find details defining this for 10BaseT networks but not for 100BaseT. Can anybody help with details of maximum number of switches? Apologies if this is not the right newsgroup for this. TIA Chris -- Chris Watts Please reply via the newsgroup/mailing list - that way we all benefit from the discussion. Private, or personal, messages should begin the Subject line with [NEWS] to ensure that they pass my spam trap. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Starts booting then h/w switches off | John[_6_] | Setup & Installation | 1 | November 20th 07 07:46 PM |
WME switches | Norman | General | 5 | February 19th 07 08:41 PM |
Number of switches - 100BaseT | Chris Watts | Networking | 2 | November 7th 05 09:20 PM |
Computer Switches Off on Own | Boo | General | 4 | September 28th 04 10:09 PM |
Excessive collisions at 100BaseT | Richard Broughton | Networking | 3 | June 28th 04 07:40 PM |