If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Colors and pixels incorrect after re-install of Windows 98
I just re-formatted a PC for a friend. The Monitor is a
15" Philips 105S/CM2300 CRT. It displays lots of dots and grainy pictures, and also has poor colors. I cannot change the resolution or colors by going to the display properties/settings. It only has 2 color choices.......2 or 16. This monitor was always clear and distinct until the hard drive was f-disked. Can anybody help me please? |
#2
|
|||
|
|||
Colors and pixels incorrect after re-install of Windows 98
This is not a monitor issue - it is related to the video adapter card. Do
Start / Run / MSConfig and make sure Normal Startup is selected. Choose Advanced and make sure VGA 640x480x16 is NOT selected. Do Start / Settings / Control Panel / Display / Settings / Advanced / Adapter and note the adapter description. If this is some type of generic VGA driver, or if it doesn't exactly match the adapter installed in your machine, then you need to find and install the video adapter drivers specific to your particular hardware. These should be available at the video adapter card manufacturer's www site, or if the video adapter is integrated into the motherboard then it should be available at the motherboard manufacturer's www site. You may have been provided with a CD as part of your system deal - in that case the drivers should be on that CD. If you have upgraded your video adapter since you bought the machine then the upgrade should have included a CD that would have the drivers on it. -- Jeff Richards MS MVP (DTS) "ultralightpilot" wrote in message ... I just re-formatted a PC for a friend. The Monitor is a 15" Philips 105S/CM2300 CRT. It displays lots of dots and grainy pictures, and also has poor colors. I cannot change the resolution or colors by going to the display properties/settings. It only has 2 color choices.......2 or 16. This monitor was always clear and distinct until the hard drive was f-disked. Can anybody help me please? |
Thread Tools | |
Display Modes | |
|
|