A Windows 98 & ME forum. Win98banter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » Win98banter forum » Windows ME » General
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

Re-installing on laptop with no CD drive



 
 
Thread Tools Display Modes
  #1  
Old September 13th 08, 07:20 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
Alpha
External Usenet User
 
Posts: 6
Default Re-installing on laptop with no CD drive

We need to re-install Windows 98 SE or ME or 2K-Pro on a laptop that has its
CD drive internal connection damaged. The floppy drive works though.

We have all the original Windows CDs and a Win98 boot floppy, as well as all
the required drivers. The unit originally had Win98 on it that was later
upgraded to WinME and subsequently to Win2K-Pro.

Can we - take out the hard drive and format it (using appropriate existing
adapters) in FAT on another machine and -
copy the CD contents and device drivers to an install folder, and -
put that drive back into the laptop, and -
boot with the Win98 floppy, and -
run Setup from the install folder, bypassing the CD drive?

Somebody says this can be done but I wanted to hear from the learned folks
here first before proceeding.

Regards and TIA

Alpha
-------














  #3  
Old September 13th 08, 07:53 PM posted to microsoft.public.win2000.general,microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general
Corday[_3_]
External Usenet User
 
Posts: 138
Default Re-installing on laptop with no CD drive

I'm sure you'll get a lot of answers on this, but I'd see how much a CD drive
repair would cost. If doable, then putting 2K back on would be the best idea.
--
I mastered Wordstar graphics!


"Alpha" wrote:

We need to re-install Windows 98 SE or ME or 2K-Pro on a laptop that has its
CD drive internal connection damaged. The floppy drive works though.

We have all the original Windows CDs and a Win98 boot floppy, as well as all
the required drivers. The unit originally had Win98 on it that was later
upgraded to WinME and subsequently to Win2K-Pro.

Can we - take out the hard drive and format it (using appropriate existing
adapters) in FAT on another machine and -
copy the CD contents and device drivers to an install folder, and -
put that drive back into the laptop, and -
boot with the Win98 floppy, and -
run Setup from the install folder, bypassing the CD drive?

Somebody says this can be done but I wanted to hear from the learned folks
here first before proceeding.

Regards and TIA

Alpha
-------















  #4  
Old September 13th 08, 07:58 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
John John (MVP)
External Usenet User
 
Posts: 54
Default Re-installing on laptop with no CD drive

You can install from a flat folder and MS-DOS. If your goal is to
install Windows 2000 copy the i386 folder from the Windows 2000 CD to
the hard drive and then start the Setup with a Windows 98 Startup
diskette, that entails of course that the drive will be formated FAT32.
Make sure that you have smartdrv.exe on the W98 startup floppy.

After you copy the i386 folder to the hard disk you can then start the
Windows 2000 installation from MS-DOS by executing WINNT from the i386
folder on the hard disk.

See here for typical instructions:
http://support.microsoft.com/kb/315349

The instructions are for XP but it's the same thing for Windows 2000.

You can convert the file system to NTFS after the installation but make
sure that the partition is aligned to a 4K boundary or else you will end
up with 512 byte clusters. http://aumha.org/win5/a/ntfscvt.php

John

Alpha wrote:

We need to re-install Windows 98 SE or ME or 2K-Pro on a laptop that has its
CD drive internal connection damaged. The floppy drive works though.

We have all the original Windows CDs and a Win98 boot floppy, as well as all
the required drivers. The unit originally had Win98 on it that was later
upgraded to WinME and subsequently to Win2K-Pro.

Can we - take out the hard drive and format it (using appropriate existing
adapters) in FAT on another machine and -
copy the CD contents and device drivers to an install folder, and -
put that drive back into the laptop, and -
boot with the Win98 floppy, and -
run Setup from the install folder, bypassing the CD drive?

Somebody says this can be done but I wanted to hear from the learned folks
here first before proceeding.

Regards and TIA

Alpha
-------














  #5  
Old September 13th 08, 08:09 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
Alpha
External Usenet User
 
Posts: 6
Default Thanks! ( Re-installing on laptop with no CD drive)

"Alpha" wrote in message
...
We need to re-install Windows 98 SE or ME or 2K-Pro on a laptop that has
its
CD drive internal connection damaged. The floppy drive works though.

-------


Thanks for the very quick and informative responses!
This will be really helpful here now.
Regards and thanks again. God Bless!


  #6  
Old September 13th 08, 08:18 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
98 Guy
External Usenet User
 
Posts: 2,951
Default Re-installing on laptop with no CD drive

Alpha wrote:

Can we - take out the hard drive and format it (using appropriate
existing adapters) in FAT on another machine and -
copy the CD contents and device drivers to an install folder,
and - put that drive back into the laptop, and -
boot with the Win98 floppy, and -
run Setup from the install folder, bypassing the CD drive?


Yes, you can do that.

In fact, if you remove the laptop's hard drive and slave it to another
PC, yes you can fdisk and format the hard drive, and put the dos system
files on the drive (format drive: /s) to make it bootable.

Then you can copy the contents of a win-98 CD to the drive (I'd copy it
to it's own directory, like c:\win98-cd).

While the drive is still slaved to another PC, that is a good time to
transfer other installation CD's to the drive - like Microsoft office or
other apps. It's also a good time to download win-98 drivers for the
laptop's video hardware, motherboard chipset, ethernet and usb hardware,
etc. It's far easier to install them once they're already on the drive.

Don't forget to put a copy of winzip on the drive as well, as it will
probably be needed to unzip those driver files.

When it's all done, and the drive is back in the laptop, just make sure
that there is no file on the drive called "win.com". Sometimes (or most
times) the presence of that file anywhere on a system will prevent
win-98 installation.
  #7  
Old September 13th 08, 09:59 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
Jeff Richards
External Usenet User
 
Posts: 1,526
Default Re-installing on laptop with no CD drive

Do not format that drive while it is installed in another machine. Format
it before removing it from the laptop, and use the other installation only
for copying the installation files onto the drive.
--
Jeff Richards
MS MVP (Windows - Shell/User)
"Alpha" wrote in message
...
We need to re-install Windows 98 SE or ME or 2K-Pro on a laptop that has
its
CD drive internal connection damaged. The floppy drive works though.

We have all the original Windows CDs and a Win98 boot floppy, as well as
all
the required drivers. The unit originally had Win98 on it that was later
upgraded to WinME and subsequently to Win2K-Pro.

Can we - take out the hard drive and format it (using appropriate existing
adapters) in FAT on another machine and -
copy the CD contents and device drivers to an install folder, and -
put that drive back into the laptop, and -
boot with the Win98 floppy, and -
run Setup from the install folder, bypassing the CD drive?

Somebody says this can be done but I wanted to hear from the learned folks
here first before proceeding.

Regards and TIA

Alpha
-------
















  #8  
Old September 13th 08, 10:22 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
98 Guy
External Usenet User
 
Posts: 2,951
Default Re-installing on laptop with no CD drive

Jeff Richards wrote:

Do not format that drive while it is installed in another machine.


Why not?

If he connects the drive to another system, and then boots the other
system into DOS with a win-98 floppy with fdisk and format on it, he
should have no problems.

Format it before removing it from the laptop,


Do that, or connect it as described above.

and use the other installation


you mean system?

only for copying the installation files onto the drive.


And other files / apps, as described in the previous post.
  #9  
Old September 13th 08, 10:59 PM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
Jeff Richards
External Usenet User
 
Posts: 1,526
Default Re-installing on laptop with no CD drive

There is no guarantee that a drive formatted in one machine will be
recognised as validly formatted when installed in another machine, and that
is especially true if the machines are very different, eg a laptop and a
desktop. It's even the case if the OP takes care to ensure that BIOS
settings for the drive are exactly the same or the machines are allowed to
autodetect..
--
Jeff Richards
MS MVP (Windows - Shell/User)
"98 Guy" wrote in message ...
Jeff Richards wrote:

Do not format that drive while it is installed in another machine.


Why not?

If he connects the drive to another system, and then boots the other
system into DOS with a win-98 floppy with fdisk and format on it, he
should have no problems.

Format it before removing it from the laptop,


Do that, or connect it as described above.

and use the other installation


you mean system?

only for copying the installation files onto the drive.


And other files / apps, as described in the previous post.



  #10  
Old September 14th 08, 05:55 AM posted to microsoft.public.win98.gen_discussion,microsoft.public.windowsme.general,microsoft.public.win2000.general
98 Guy
External Usenet User
 
Posts: 2,951
Default Re-installing on laptop with no CD drive

Top-poster Jeff Richards wrote:

There is no guarantee that a drive formatted in one machine will be
recognised as validly formatted when installed in another machine,


What are you smoking?

The *only* problem I've ever seen regarding formatting and subsequent OS
installation was when I created a FAT-32 partition to install XP on
using OnTrack's Disk Manager and it gave a choice for OS installation
and I didn't think it mattered so I chose Windows-ME and the install
continuously failed until I re-partitioned using the "XP" choice.

and that is especially true if the machines are very different,
eg a laptop and a desktop.


Bull crap.

If you take any machine, attach a hard drive to it, boot DOS with a
win-98 floppy containing fdisk and format, and then partition, format
and sys the hard drive, that drive will have a logical structure that
will be no different than if it was partitioned and formatted on any
other system and it will boot into dos when connected to any other
system.

This assumes that the bios is compatible with the size of the drive, and
that the user hasn't entered any crazy-ass head and sector information
in the cmos setup. If the drive is less than 32 gb, then it's a
non-issue. If either system motherboard is less than 6 years old, then
it's a non-issue.
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Re-installing on laptop with no CD drive Alpha General 14 September 15th 08 05:36 AM
Installing Windows ME on a laptop Countryboy Setup & Installation 0 October 14th 04 03:05 AM
installing Win 98 SE on a laptop manufactured in '04 Dingell Norwood Setup & Installation 1 October 11th 04 10:52 PM
Installing Win 98 on laptop sheppardwk Setup & Installation 6 September 2nd 04 03:05 PM
installing w98se over w95 in a laptop keyboard not same! garlobo Setup & Installation 1 June 26th 04 02:14 AM


All times are GMT +1. The time now is 03:51 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 Win98banter.
The comments are property of their posters.