If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Delayed Video
A win98 2nd Ed system was freezing up when several programs were opened so I
added more Ram. It had 64Mb; now 320Mb. Then I was going to boot iun safe mode to run scandisk, but when the menu appeared the kb was inactive. If I allowed it to boot normally the kb works. I have a usb kb so I swithed it back to it's older kb and it worked in the boot menu to allow me to boot into safe mode. Now, using the newer kb, the video is delayed quite a bit after I press a key on the kb. Any ideas? Thanks. |
#2
|
|||
|
|||
Delayed Video
Have you checked/upped the Refresh Rate in Display Properties Settings tab
Advanced button Monitor tab? -- Brian A. Sesko { MS MVP_Shell/User } Conflicts start where information lacks. http://basconotw.mvps.org/ Suggested posting do's/don'ts: http://www.dts-l.org/goodpost.htm How to ask a question: http://support.microsoft.com/kb/555375 SAC wrote: A win98 2nd Ed system was freezing up when several programs were opened so I added more Ram. It had 64Mb; now 320Mb. Then I was going to boot iun safe mode to run scandisk, but when the menu appeared the kb was inactive. If I allowed it to boot normally the kb works. I have a usb kb so I swithed it back to it's older kb and it worked in the boot menu to allow me to boot into safe mode. Now, using the newer kb, the video is delayed quite a bit after I press a key on the kb. Any ideas? Thanks. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
old pc - no video - need help | cosmo | General | 6 | May 27th 06 02:41 AM |
video card displaying garbage during setup of windows 98SE | Edward Letendre | Setup & Installation | 0 | May 25th 06 12:00 AM |
Graphics Card Problem & error code 10? | Susan | Hardware | 34 | May 23rd 05 03:45 PM |
Freezing and More | jane | General | 68 | February 16th 05 11:10 AM |
Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |