|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 23rd 04, 08:26 PM
|
|||
|
|||
MS-DOS Compatability & 2 Hard Drives
I recently installed a 2nd hard drive, copied the drive as new boot drive;
set new drive as C: and old drive as D:. Problem is... I ended up in DOS Compatability mode. Is this because there are 2 bootable drives connected? (As long as only one of the drives is connected -- performance is optimal) Thanks, Dave 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large Hard drives | [email protected] | General | 4 | August 17th 04 01:49 PM |
| How can I make 2 hard drives act like one | fruitlesspuppy | General | 4 | July 23rd 04 05:43 PM |
| hard drives | ron | General | 7 | July 17th 04 08:00 PM |
| Dual boot ME and XP with 4 hard drives (questions) | [email protected] | General | 6 | July 6th 04 08:57 PM |
| Booting brings up all hard drives | Daniel Louwrens | General | 9 | June 6th 04 02:52 AM |
Linear Mode
