If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CD-ROM and CD Burner
I can only get my CD-ROM or My CD Burner to work, but not
both. I have tried all the combinations of the jumper switch on back of the CD-ROM/ Burner. I notice that when I boot up the computer that it stops at the Ambioso and looks for the CD-ROM. I notice at that point under the ATAPI DEVICE that the secondary slave has a N/A under the UDMA column but the Primary Master and Secondary Master have "2". Could this be the problem? If so how do you change it? Any other suggestions. |
Thread Tools | |
Display Modes | |
|
|