If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
setup message
When I install windows 98 se on this compaq deskpro en system, I get the
following message after the installation finishes installing and the system restarts. standard mode:fault outside of ms-dos extended ec=0000 cs=0367 ip=74d0 ax=0000 bx=0367 cx=ffb1 dx=0367 si=2aba di=721d bp=0fp0 ds=036f es=035f ss=027f sp=0f94 What does this mean and how do I work aound it? Thanks,Bob -- RDF Message posted via http://www.windowskb.com |
#2
|
|||
|
|||
setup message
On Mon, 31 Jul 2006 21:43:31 GMT, "rdf1941 via WindowsKB.com"
u24395@uwe wrote: When I install windows 98 se on this compaq deskpro en system, I get the following message after the installation finishes installing and the system restarts. standard mode:fault outside of ms-dos extended ec=0000 cs=0367 ip=74d0 ax=0000 bx=0367 cx=ffb1 dx=0367 si=2aba di=721d bp=0fp0 ds=036f es=035f ss=027f sp=0f94 What does this mean and how do I work aound it? Thanks,Bob If that's extender, see this MS article: Windows Err Msg: Fault in MS-DOS Extender http://support.microsoft.com/support...s/Q87/2/39.ASP Regards, Bill Watt Win98 Computer Help & Other Information http://home.ptd.net/~bwatt/ |
#3
|
|||
|
|||
setup message
On Tue, 01 Aug 2006 00:44:00 -0400, Bill Watt
wrote: On Mon, 31 Jul 2006 21:43:31 GMT, "rdf1941 via WindowsKB.com" u24395@uwe wrote: When I install windows 98 se on this compaq deskpro en system, I get the following message after the installation finishes installing and the system restarts. standard mode:fault outside of ms-dos extended ec=0000 cs=0367 ip=74d0 ax=0000 bx=0367 cx=ffb1 dx=0367 si=2aba di=721d bp=0fp0 ds=036f es=035f ss=027f sp=0f94 What does this mean and how do I work aound it? Thanks,Bob If that's extender, see this MS article: Windows Err Msg: Fault in MS-DOS Extender http://support.microsoft.com/support...s/Q87/2/39.ASP The causes are the same as those for the "Fault in MS-DOS Extender" error in the article. I would check the config.sys file for an error and also run an up to date Anti-virus scan. If no help then boot to the BIOS and see if all is ok there. Regards, Bill Watt Win98 Computer Help & Other Information http://home.ptd.net/~bwatt/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Other or alternative Windows Updates | MEB | General | 3 | March 4th 06 04:20 AM |
Win 98 Error Message | Arbaca | General | 20 | July 21st 05 11:59 PM |
Error updating from 98 to 98SE | Jerry C. | Setup & Installation | 26 | May 29th 05 08:19 AM |
Error Loading OS | Herman Berliss, MD | General | 29 | February 21st 05 03:44 PM |
Invalid page fault | baxter | General | 13 | December 6th 04 04:37 AM |