If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Error Message on Bootup...
Hello,
I see this 'error' message on bootup: 'Cannot set the code page(s) in WINDOWS.SYS'. And System Restore ceases to function when triggered, at about mid-point on the progress bar so I use ALT|CTRL|DEL to stop it's operation. A reboot reveals it 'cannot restore'. Help appreciated. Ben. |
#2
|
|||
|
|||
Error Message on Bootup...Posted in Error - Ignore.
Hello. This posted in error. Apologies.
-----Original Message----- Hello, I see this 'error' message on bootup: 'Cannot set the code page(s) in WINDOWS.SYS'. And System Restore ceases to function when triggered, at about mid-point on the progress bar so I use ALT|CTRL|DEL to stop it's operation. A reboot reveals it 'cannot restore'. Help appreciated. Ben. . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
bootup | VSP | General | 4 | July 24th 04 02:48 AM |
bootup disk | marligreen | Setup & Installation | 2 | July 23rd 04 03:32 PM |
win98 registry bootup problem | Mark | General | 1 | July 5th 04 08:57 PM |
scandisk on bootup | Jason | General | 4 | June 27th 04 05:15 PM |
Screen blinks off at bootup | Arsenio Oloroso | Improving Performance | 2 | May 10th 04 06:46 PM |