Can't load the DLL library

I recently put a new HDD in an old computer and
replaced the W98SE OS. I had saved the drivers
and got the system operating again without too much
trouble. However, when I tried to load some ATT dial-up
connection software I got the message "Cannot load the
DLL library D:\WINCLIENT\wisehlp.dll". I verified that
the component is on the CDROM and I also copied it
to the C drive. The results are the same when I use the
copy on the C drive. Later I tried to load some software
from Linksys and got a message "Cannot load ProcNICs
9x.dll. Is there any reason to think my installation caused
this problem with dll files? This is the most serious problem
that I have noticed since the installation. Any ideas?

"merkinp" wrote in message
...

I recently put a new HDD in an old computer and
replaced the W98SE OS. I had saved the drivers
and got the system operating again without too much
trouble. However, when I tried to load some ATT dial-up
connection software I got the message "Cannot load the
DLL library D:\WINCLIENT\wisehlp.dll". I verified that
the component is on the CDROM and I also copied it
to the C drive. The results are the same when I use the
copy on the C drive. Later I tried to load some software
from Linksys and got a message "Cannot load ProcNICs
9x.dll. Is there any reason to think my installation caused
this problem with dll files? This is the most serious problem
that I have noticed since the installation. Any ideas?

Your trouble appears to be in the ATT software.
No DLL WISEHLP or PROCNIC appears in the
MS inventory of DLLs catalogued at
http://support.microsoft.com/dllhelp...lp&S=1&x=0&y=0

The simplest route to solution may be to uninstal
the ATT software via Control Panel and verify
whether this software is for Win98.

--
Don Phillipson
Carlsbad Springs
(Ottawa, Canada)

"merkinp" wrote in message
...
I recently put a new HDD in an old computer and
replaced the W98SE OS. I had saved the drivers
and got the system operating again without too much
trouble. However, when I tried to load some ATT dial-up
connection software I got the message "Cannot load the
DLL library D:\WINCLIENT\wisehlp.dll". I verified that
the component is on the CDROM and I also copied it
to the C drive. The results are the same when I use the
copy on the C drive. Later I tried to load some software
from Linksys and got a message "Cannot load ProcNICs
9x.dll. Is there any reason to think my installation caused
this problem with dll files? This is the most serious problem
that I have noticed since the installation. Any ideas?


software gnenerally needs to be *installed* rather than just copying a
..dll to you C: drive.
but sometimes you can get such apps to work by copying the needed .dll's
to the proper place on your C: drive.

try the windows\system folder
or system32