If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can not get command prompt
Dear friends,
I had windows 98 as my operating system. I tried to upgrade it to windows 2000 pro, but some error occurred and trial failed. Now while booting I was prompted two options with windows 2000 as the default choice and 5 seconds to shift to windows 98. So I tried to modify the boot.ini file. But by mistake I damaged the boot.ini file and now I am not getting screen option of windows 98 . My only option is switching over to windows 2000 which is not functioning. I activated the booting option by using F8. I tried using all the modes like safe mode, safe mode with networking, safe mode with command prompt, enable boot logging and the others. But by pressing any of the above options I am again being directed to windows 2000 boot up and my PC is getting hanged. My floppy drive is not working? I changed the boot sequence in CMOS set up and tried to boot from CD with bootable CD. But while booting I am getting message “ Boot from ATAPI CD-ROM : CD-ROM Loader v1.2 BETA 09/07/01 © 2001 BY Bart Lagerweij.� Please note that my CD drive ( sony CD writer) is working fine otherwise within an operating system. I tried all boot up sequences and all CMOS setup options. I am not able to start my PC. How to get command from for my hard drives as well as that CD drive? Dhuri |
Thread Tools | |
Display Modes | |
|
|