If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
usb conflict
I followed Microsoft Knowledge Base #299264 through all
the steps to extract three files. After giving permission to overwrite the needed files, the computer went to the a: prompt. What command am I to use? Are there other prompts I will receive? How do I respond to them? I don't understand ms-dos. Thanks for your help. |
#2
|
|||
|
|||
usb conflict
If you read KB299264 you will see that is provides detailed instructions
including the command (EXT) you need to use to replace the three files. This from your post I assume you have done. Once you have completed using the EXT command and replaced the three files you are finished and can remove the boot floppy and reboot back into Win Me. What do you see in the Device Manager when you boot back into Win Me? Do you still see "The NTKERN.VxD device loaders for this device could not load the device driver (Code 2)." when you check the usb device controller? -- Mike Maltby MS-MVP chris wrote: I followed Microsoft Knowledge Base #299264 through all the steps to extract three files. After giving permission to overwrite the needed files, the computer went to the a: prompt. What command am I to use? Are there other prompts I will receive? How do I respond to them? I don't understand ms-dos. Thanks for your help. |
#3
|
|||
|
|||
usb conflict
Yes, I still see that exact message in the device mgr. I
neglected to tell you after the three files were overwritten, at the a:\ prompt I did remove the floppy & rebooted to WinME. -----Original Message----- If you read KB299264 you will see that is provides detailed instructions including the command (EXT) you need to use to replace the three files. This from your post I assume you have done. Once you have completed using the EXT command and replaced the three files you are finished and can remove the boot floppy and reboot back into Win Me. What do you see in the Device Manager when you boot back into Win Me? Do you still see "The NTKERN.VxD device loaders for this device could not load the device driver (Code 2)." when you check the usb device controller? -- Mike Maltby MS-MVP chris wrote: I followed Microsoft Knowledge Base #299264 through all the steps to extract three files. After giving permission to overwrite the needed files, the computer went to the a: prompt. What command am I to use? Are there other prompts I will receive? How do I respond to them? I don't understand ms-dos. Thanks for your help. . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hardware conflict - conflicting system messages | Tim | General | 3 | August 9th 04 02:48 PM |
PNP BIOS conflict | Tim | General | 3 | August 6th 04 03:36 AM |
USB Port Hardware Conflict | Lou | General | 0 | August 5th 04 08:52 PM |
Disk - Resource Conflict | George S | Disk Drives | 2 | July 2nd 04 08:50 AM |
LSP conflict - eTrust EZ Antivirus | Franz Bruck | Software & Applications | 4 | June 16th 04 07:14 PM |