If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
scandisk want to run a surface scan at almost every boot
Friday Morn
During bootup scandisk informs me of need to run a thorough suface scan. I sometimes let it do this: takes nearly 3 hours. And after a couple of boots, it wants to do it again. Nothing is wrong with the drives. How do I manually reset the scandisk flag? J |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No Info in Cofig.sys or Autoexec. | Ralph Jaggi | General | 84 | July 19th 04 09:44 PM |
"no OS found | john | General | 3 | July 4th 04 07:50 PM |
scandisk want to run a surface scan at almost every boot | J | General | 27 | June 29th 04 09:30 PM |
Hard drive clicking then surface scan. | keith | General | 8 | June 21st 04 07:39 PM |
Scan Disk Defrag stop - Disk Surface Corrupted? | Laura Lee | Disk Drives | 1 | May 20th 04 08:56 AM |