If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
System Restore
I cannot use system restore in my Windows ME. When I
booted up my computer, I got an error message that windows were improperly shut down. Scandisk failed so I cancelled the scan and started computer in safe mode and scanned sucessfully. sometimes when I attempt to shut down windows, i get an error message VWIN32(05) 000012D0 Error OE: 0028 C02AA44A8. Windows will start but I'm asked to restore my desktop each time. When I tried to run Restore. I get a message that "System Restore cannot run until you restart computer" I have tried several recommended solutions to no avail. I tried article Q274092, Q214643 and Q279736. I even tried to go MSDOS and Scanreg /restore with no sucess. What else can I do. I did recently install Netzero High Speed. HELP |
#2
|
|||
|
|||
System Restore
It would probably be sensible to have posted separate threads for the
different problems you are experiencing. For example your shutdown problem probably has little or nothing to do with your problem when using system restore. Your system restore problem. Rather than using SCANREG /RESTORE as suggested in Q274092, instead use SCANREG /FIX. SCANREG /RESTORE is unlikely to be of any help unless the problem with system restore being unable to create checkpoints has only occurred in the last five days. This error will ("System Restore cannot run until you restart computer") means however that you are unlikely to have an usable checkpoints since this particular problem started. It is also for this reason that you would have been unable to use system restore from a command prompt. -- Mike Maltby MS-MVP wrote: I cannot use system restore in my Windows ME. When I booted up my computer, I got an error message that windows were improperly shut down. Scandisk failed so I cancelled the scan and started computer in safe mode and scanned sucessfully. sometimes when I attempt to shut down windows, i get an error message VWIN32(05) 000012D0 Error OE: 0028 C02AA44A8. Windows will start but I'm asked to restore my desktop each time. When I tried to run Restore. I get a message that "System Restore cannot run until you restart computer" I have tried several recommended solutions to no avail. I tried article Q274092, Q214643 and Q279736. I even tried to go MSDOS and Scanreg /restore with no sucess. What else can I do. I did recently install Netzero High Speed. HELP |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |
Cannot ENABLE System Restore. Help! | aa | General | 0 | July 3rd 04 04:05 PM |
"Restore/Temp......."Virus OEM Me | David Oltmann | General | 5 | June 8th 04 09:25 PM |
system restore inoperative | Dennis | Setup & Installation | 1 | June 7th 04 10:30 PM |
System Restore | Jerry Ross | General | 1 | May 28th 04 11:39 PM |