If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Screen Resolution
In Settings in Display, I can't change the screen area 640x480 pixels - the
window is larger than the monitor screen so that the Apply and OK command buttons at the bottom are not visible. I've moved the window up and removed the Taskbar but the buttons are not visible. I can adjust the slide bar and close the window but upon return, the slider is back at 640x480. I just added 128mB memory for a total of 256 and using Win 98SE. Any suggestions? Thanks. |
#2
|
|||
|
|||
I've found the answer: use the Enter key in place of hte Apply button.
Everything normal now. "Art Nelson" wrote in message ... In Settings in Display, I can't change the screen area 640x480 pixels - the window is larger than the monitor screen so that the Apply and OK command buttons at the bottom are not visible. I've moved the window up and removed the Taskbar but the buttons are not visible. I can adjust the slide bar and close the window but upon return, the slider is back at 640x480. I just added 128mB memory for a total of 256 and using Win 98SE. Any suggestions? Thanks. |
#3
|
|||
|
|||
After you reset the Display properties, press Enter if you cannot see the OK
button because it is off the bottom of the screen. You might have to press Tab once or twice to advance the cursor to the OK button which you cannot see because it's off the bottom of the screen. Joe "Art Nelson" wrote in message ... In Settings in Display, I can't change the screen area 640x480 pixels - the window is larger than the monitor screen so that the Apply and OK command buttons at the bottom are not visible. I've moved the window up and removed the Taskbar but the buttons are not visible. I can adjust the slide bar and close the window but upon return, the slider is back at 640x480. I just added 128mB memory for a total of 256 and using Win 98SE. Any suggestions? Thanks. |
#4
|
|||
|
|||
Make the change and press Enter. It's the same as Apply/Ok.
--=20 Brian A. Conflicts start where information lacks. http://www.dts-l.org/goodpost.htm "Art Nelson" wrote in message = ... In Settings in Display, I can't change the screen area 640x480 pixels = - the=20 window is larger than the monitor screen so that the Apply and OK = command=20 buttons at the bottom are not visible. I've moved the window up and = removed=20 the Taskbar but the buttons are not visible. I can adjust the slide = bar and=20 close the window but upon return, the slider is back at 640x480. I just added 128mB memory for a total of 256 and using Win 98SE. Any=20 suggestions? Thanks.=20 =20 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Screen size | Trinidad Latvel | Improving Performance | 2 | July 12th 04 09:43 PM |
black screen at windows start | Coyote | General | 2 | July 7th 04 12:25 PM |
Startup screens resolution problem | Julia | General | 7 | June 30th 04 09:38 PM |
Screen resolution up the creek! | Ritchie | Monitors & Displays | 1 | June 18th 04 04:00 AM |
i have an IBM thinkpad that will not change its screen resolution | jc calling | Monitors & Displays | 2 | June 5th 04 07:15 PM |