If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
SCSI controller - 'code 10'
Hi,
Hope someone can help? Have a problem - my system started in safemode so I restarted it but the display had altered (ghost-like and colours altered but settings unchanged). Looked in Device manager and have the yellow exclamation mark under "SCSI Controllers" for "DMX3181X ISA SCSI Host Adapter" (other listed is for EPPSCSI miniport driver - all ok). Under resources tab says code 10 - device drivers either not present or not working properly. Have searched everywhere to reinstall but can't find the original driver in my system. Anyway, is this affecting the display or is this 'host adapter' only related to my scanner? I'm confused! I need to get my display happening again and can't. Where can I get new drivers for that and what info do you need to help? Many thanks for any assistance. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boot | KB | General | 8 | May 15th 05 11:39 PM |
WinMe conflict w/ Intel 82371 AB/EB PCI Bus Master IDE Controller | Fernando Reyes | Hardware | 2 | September 22nd 04 12:46 AM |
Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |
Seeking SCSI controller driver | Joe | Setup & Installation | 1 | June 11th 04 10:57 PM |
IDE Controller Error (Code 10) | Graham Womack | General | 6 | June 5th 04 10:25 PM |