If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Turns out my modem was only getting -22 db on channel 85 at 591 Mhz., after the
splitter the TV cable guy put in; so the Cable light on the modem kept going out. At the wall jack, the level was -12 db on channel 85. There is a steep rolloff of good frequency response somewhere between channel 77 and channel 85 from the wire inside the wall; this is using RG-59 cable and not the RG-6 cable. There was another outlet in my bedroom that was nearer to the laundry room where the the lockbox is located. The output from there was -9 db at the wall at 591 Mhz. In order for the cable internet tech to use a splitter, he needs +0 db or better from the wall; and all he got were negative numbers at the frequency used. So he ran a long cable from my bedroom to my computer modem in my living room. I don't think that setup is gonna pass apartment inspection next year! However, since he took the splitter off of my TV set too, the signal on my TV screen is much improved, but still not as good as my parents TV cable signal a couple of blocks away. I'm using an active 4 way splitter to plug in my 2 VCR's, DVD burner tuner, and my TV set; and I set the gain on the splitter all the way up. It's a bi-directional splitter, so if digital services ever wind up in here, the splitter could handle them...maybe. Channels above 60 still get snowy; but a couple of days ago, the snowiness extended down to channel 21 because of the splitter for the internet connection. I still blame the cable inside the wall for the snowiness that still exists, but I will not have an internet connection splitter on that outlet again!!! So, my question is, how do I get rid of this long cable without suffering EMF effects from a wireless router in my bedroom? I'm very sensitive to EMF, and I can feel the induction of ionizers in my balls! I have to wear a magnetized bracelet to help counteract the physical effects I get from ionizers, and put the ionizers on a multi-event timer! Can a wireless router work with a modem that is running from a -9 db signal? Can I run a wireless router with the base unit that far away from my computer? I'd like to use wireless USB adapters for my current and future computers for the remote computer hookups. I'm thinking of using the Linksys brand. The tech said that the modem should be running from a signal of -8 db or better, and that the wire in the wall should be replaced; but that it would cost the landlord over $10,000 to replace all of the 30 year-old RG-59 wire with brand new RG-6 wire. Nobody is in a position of authority to force the landlord to replace the wire. If the landlord did replace the wire, a lot of walls in the complex may suffer damage from the process. |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Internet connection is lost after 1 min. | Jason | Internet | 1 | August 2nd 04 07:30 PM |
lost internet connection through NIC, now dials modem | Stephan | General | 4 | July 22nd 04 04:30 AM |
lost internet connection through NIC, now dials modem | Stephan | Internet | 4 | July 22nd 04 04:30 AM |
Lost internet connection | Kirk | Internet | 0 | July 18th 04 11:25 PM |
Real says I lost my connection, but it doesn't try to reestablish one. | meirman | Multimedia | 0 | July 7th 04 02:44 AM |