If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
After installing updates
I have reformated and loaded Windows 98SE and all of the
updateds then I installed my printer and everything went as it should - only problem is when I send a job to the printer it must get lost because nothing happens. Have done this on two computers with two different prints and neither will print. Any suggestions...... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can't unpack Compaq updates after installing WIN98 to C: drive | Mary Keats | General | 1 | September 2nd 04 12:35 PM |
Error in getting and installing critical updates | John | General | 1 | July 14th 04 10:55 PM |
installing updates | Krys | Setup & Installation | 1 | July 8th 04 06:17 AM |
Updates not installing | Melissa | General | 4 | June 28th 04 08:34 PM |
Updates Not Installing | [email protected] | General | 1 | June 1st 04 10:18 AM |