If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Network Printer port resets on boot up
I have an HP 1210 PSC printer attached to my desktop Pc running XP and shared
via network with my laptop running Windows 98. After setting the appropriate port the laptop prints to the printer just fine. However, whenever I re-boot the laptop, the port settings for the network print are changed on bootup. I must then reset the printer port on the laptop in order to print again. How can I prevent the port settings from changing every time the laptop is re-booted? Thanks, Lou |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How do I install the Deskjet 722C driver to function as a network printer rather than a dedicated PC parallel port printer | Warren | Networking | 14 | October 29th 07 03:21 AM |
"port capture" to a network printer | Donald Campbell | General | 0 | March 31st 06 08:45 AM |
"port capture" to a network printer | Donald Campbell | Setup & Installation | 0 | March 31st 06 08:45 AM |
Network Printer port resets on boot up | Lou Splen | Networking | 0 | February 6th 05 08:03 PM |
Printing problem to virtual printer port (Canon ir3100c)/How to delete virtual printer port? | [email protected] | Printing | 0 | December 17th 04 02:21 PM |