|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
June 21st 08, 04:37 PM
posted to microsoft.public.win98.networking
|
|||
|
|||
Router Modem conflict
MEB wrote:
Sounds like you should have the router connected to the highspeed modem [cable/DSL] and let your network connect via the router. The router would then assign IP addressing for the networked computers and printer [if a true network computer]. Yes, that was my original setup, since last weekend and that is what I went back to. I thought that seperate NIC's would be more secure,but that is not the case. The router is more secure,no more pop-ups on my ZoneAlarm. I will assuage my fears by installing a RJ45 switchbox, to physically disconnect the 2 machines when I don't need to print. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nat Router and 'normal' Router ?? | Ian H | General | 18 | March 16th 07 10:48 AM |
| can't get modem into modem list | Gary Roach | General | 11 | May 3rd 06 12:44 PM |
| Linksys Router BEFSR11 (Vers. 1.46.00 ) and Motorola Modem Problem. | Ben B | Hardware | 5 | November 25th 04 06:28 AM |
| VPN wth Cable Modem and router | Jeremy Poynton | Networking | 0 | September 10th 04 03:40 PM |
| cable modem/router question | sf | General | 31 | June 30th 04 08:05 AM |
Threaded Mode