If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Is this newsgroup still alive? (HELP: Win98SE won't boot on my new PC)
I recently installed Windows 98 SE on a ECS 915G-A (Intel® 915G & ICH6,
Socket 775) http://www.ecs.com.tw/ECSWeb/Product...uID=93&LanID=9 motherboard, which has built-in graphics card. Though I do have installed a Nvidia GeForce 4 440 Ti AGP. CPU is a Pentium 4 3.0GHz. Mice is USB not PS/2. Windows 98 SE installed fine. It wasn't until the reboot with message "Please wait while Windows perform post-install stuff...." that it hangs. It actually boots into Windows 98 SE in safe-mode alright, but then I don't get sound/cd-rom/network/etc. Does anyone have any idea why it is hanging in normal boot up mode? Is it because of no PS/2 mouse detected? Or something else? |
#2
|
|||
|
|||
Is this newsgroup still alive? (HELP: Win98SE won't boot on my new PC)
You need to install the drivers for the motherboard - their manual however
seems to be totally deficient on support for Win9x. Did you remember to turn off the onboard graphics in the BIOS before installing the OS? (most OS's will barf at having two sets of AGP hardware installed) -- Noel Paton (MS-MVP 2002-2006, Windows) Nil Carborundum Illegitemi http://www.crashfixpc.com http://tinyurl.com/6oztj Please read http://dts-l.org/goodpost.htm on how to post messages to NG's "Dhruba Bandopadhyay" wrote in message ... I recently installed Windows 98 SE on a ECS 915G-A (Intel® 915G & ICH6, Socket 775) http://www.ecs.com.tw/ECSWeb/Product...uID=93&LanID=9 motherboard, which has built-in graphics card. Though I do have installed a Nvidia GeForce 4 440 Ti AGP. CPU is a Pentium 4 3.0GHz. Mice is USB not PS/2. Windows 98 SE installed fine. It wasn't until the reboot with message "Please wait while Windows perform post-install stuff...." that it hangs. It actually boots into Windows 98 SE in safe-mode alright, but then I don't get sound/cd-rom/network/etc. Does anyone have any idea why it is hanging in normal boot up mode? Is it because of no PS/2 mouse detected? Or something else? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reload Win98SE over original | Rick_Urquhart | General | 69 | December 16th 05 06:21 AM |
Win98SE boot problem | AMW | Setup & Installation | 1 | July 12th 05 10:55 PM |
error message | bill | General | 7 | August 10th 04 02:09 AM |
HP logo appears twice...Win98SE can only boot to SAFE MODE | mt | General | 6 | June 26th 04 10:15 PM |
MBR switch on FDISK | jt3 | General | 30 | June 21st 04 08:56 PM |