If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
NetBios Name Resolution Failure
I have a XP MCE2005 computer tied to a Dlink router via ethernet cable. The
second cpu is run W98SE via a pci card. The XP unit can see the 98 unit and access the hard drive. The 98 computer has internet access, but not networking. It cannot see the xp computer. After creating a network disk on the xp unit and running on the 98 machine, the 98 will see the network & xp unit after the final boot after installation. However, once the 98 unit is shut down \rebooted, it can not longer access or see the network. I have turned off microsoft fire wall and uninstalled Z Alarm on the XP unit. Following the troubleshooting procedures from www.practicallynetworked I have found that the 98 machine can ping the xp unit by IP adress, but not by the XP's alpha name. The troubleshooting guide indicates that this is a NetBIOS name resolution failure. I did try trouble shooting the 98 machine using nbtstat, however, I am not sure if it showing any issues. How do I resolve the netbios names failure? Thanks, Danny |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem networking ME to XPProSP3 | BulldawgKenny | Networking | 26 | September 23rd 05 07:43 PM |
Quick Resolution | jane | General | 3 | December 30th 04 03:24 PM |
OS Fault or Hardware Failure?...(very descriptive) | Dalamar | General | 7 | December 14th 04 07:38 PM |
Processor fan 1/ 2 | barry martin | General | 0 | November 3rd 04 07:23 PM |
Curious inquiry about PC failure | Star | General | 13 | August 17th 04 05:16 AM |