If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Surface Scan
My computer has started locking up after sitting idle for
a period of time (sometimes as short as 30 min.) I have to turn the power off. While it is booting up after I turn the power back on it goes to a surface scan for Drive C looking for bad clusters. This takes about 45 min. to complete. What is causing this and how can I get out of it. |
#2
|
|||
|
|||
Do you have any programs running?, have you cleared the Temp/TIF/cookies etc
folders?, ran defrag? -- Regards Steven Burn Ur I.T. Mate Group www.it-mate.co.uk Keeping it FREE! "DKW" wrote in message ... My computer has started locking up after sitting idle for a period of time (sometimes as short as 30 min.) I have to turn the power off. While it is booting up after I turn the power back on it goes to a surface scan for Drive C looking for bad clusters. This takes about 45 min. to complete. What is causing this and how can I get out of it. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
IESEARCH | BigMig | Internet | 4 | July 3rd 04 08:29 AM |
scandisk want to run a surface scan at almost every boot | J | General | 27 | June 29th 04 09:30 PM |
Hard drive clicking then surface scan. | keith | General | 8 | June 21st 04 07:39 PM |
scandisk want to run a surface scan at almost every boot | J | Disk Drives | 0 | June 11th 04 04:59 PM |
Scan Disk Defrag stop - Disk Surface Corrupted? | Laura Lee | Disk Drives | 1 | May 20th 04 08:56 AM |