If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Slave Hard Drive
How do I get Me to recognize the slave hard drive in my
computer so that I can access it. The system shows the slave there but I cant access it. Thanks for any help. |
#2
|
|||
|
|||
Slave Hard Drive
Have you fdisked, partitioned and formatted the drive? If not then you won't
be able to see the drive in Explorer. For details of how to fdisk and format see the Microsoft Knowledge Base article 255867 - "How to Use the Fdisk Tool and the Format Tool to Partition or Repartition a Hard Disk" (http://support.microsoft.com/?kbid=255867). -- Mike Maltby MS-MVP cdr4597 wrote: How do I get Me to recognize the slave hard drive in my computer so that I can access it. The system shows the slave there but I cant access it. Thanks for any help. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cloning Hard Drive | damo | General | 1 | July 15th 04 11:16 PM |
How to thoroughly clean hard drive for Win98 installation? | Old Geezer | General | 10 | July 6th 04 05:03 AM |
Zero-byte D: drive should not show, C: missing from Device Manager | *Vanguard* | General | 8 | June 12th 04 04:19 AM |
Large Hard Drive & BIOS upgrade problems | Lago Jardin | General | 17 | June 11th 04 07:27 PM |
New 120 GIG Hard Drive: Garbled Folder appeared | Lago Jardin | General | 19 | May 28th 04 08:24 PM |