If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Decoding
I have downloaded a program with instructions. When
opening the instructions I get a lot of computer data that is not in english (000yyy etc.) Is there a way to convert this dialog to english??? Please advise. |
#2
|
|||
|
|||
Decoding
What application (viewer) are you using to read the instructions where you
see "000yyy etc."? What suffix does the 'Instructions' file have - e.g. 'Instructions.doc', 'Instructions.txt', 'Instructions.pdf', etc.? You *may not* have an application on your computer that will read it correctly. Mart "rosedfaykiz" wrote in message ... I have downloaded a program with instructions. When opening the instructions I get a lot of computer data that is not in english (000yyy etc.) Is there a way to convert this dialog to english??? Please advise. |
Thread Tools | |
Display Modes | |
|
|