If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clean install Win98se problem
Hi
I have an old Win98se HP computer which I am going to give to my Grandson. I want to do a clean install and have inserted the rescue floppy and restore disc 1 as per the instructions. I then boot up the computer and everything goes well until after the cd rom has started. A message finally appears "This computer does not have any valid information". The process then stops. Would appreciate any help. Regards Bill |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clean Install | woodbndr | Setup & Installation | 7 | May 21st 07 09:39 PM |
How and what order do I do to clean a hard disk and ready it to install win98se? | DJW | Setup & Installation | 3 | November 22nd 06 02:23 AM |
Clean Install of ME | steved | Setup & Installation | 1 | September 5th 04 09:26 PM |
WAP Utility Install Problem on Win98SE | David H. | General | 0 | August 14th 04 02:47 PM |
clean install | Victor | Software & Applications | 2 | August 11th 04 01:47 AM |