|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 7th 04, 08:30 PM
|
|||
|
|||
Serial Mouse
In Windows ME I can not get the serial mouse to work.
This is an AT motherboard with a 166MhZ processor. When I go into Control Panel and then my System I will remove my mouse and my communication port1. When I reboot the system in safe mode I can get my mouse to work. If I reboot my system in regular my mouse will work for a few seconds until the system notices the new hardware and and loads these drivers that keep it from working. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |
| Win98 SE does not recognize PS/2 mouse on cold boot, only warm | Iudith | General | 0 | June 16th 04 12:50 PM |
| Wheel Mouse won't work. Driver?? BTC M370 | Big Mac | General | 3 | June 10th 04 02:21 AM |
| MS optical mouse not working in USB | Doug Boufford | Plug & Play | 2 | June 9th 04 10:10 AM |
| need help installing a serial mouse | Jack Lee | General | 0 | June 5th 04 01:50 PM |
Linear Mode
