If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Selecting USB Ports
I have windows 98 and usually connect to Epsom Stylus colour 760 printer via a Parallel connection. (Pin connection using LPT1 Port location) I want to use a USB cable instead.
I have connected to the PC USB Port and the USB Port on the printer. However the message appears connection failure. I have re installed the printer hardware and selected printer software Win98 with no success.I have tried COM1 to no avail. Can anyone assist please? Pam |
#2
|
|||
|
|||
Turn off the printer and then remove both the printer from Control Panel,
Printers and remove the software from Control Panel, Add remove programs. Now install the software for the printer and when it says "searching for the printer", then turn on the printer that is now connected to the USB port. A port should be created by the installation for the USB connection. PattyL "Pam" wrote in message ... I have windows 98 and usually connect to Epsom Stylus colour 760 printer via a Parallel connection. (Pin connection using LPT1 Port location) I want to use a USB cable instead. I have connected to the PC USB Port and the USB Port on the printer. However the message appears connection failure. I have re installed the printer hardware and selected printer software Win98 with no success.I have tried COM1 to no avail. Can anyone assist please? Pam -- Pam |
#3
|
|||
|
|||
Is USB installed and operating properly.? For instance, can you use other
USB devices in the port you are connecting the printer to? USB installation is a separate process from printer installation. "Pam" wrote in message ... I have windows 98 and usually connect to Epsom Stylus colour 760 printer via a Parallel connection. (Pin connection using LPT1 Port location) I want to use a USB cable instead. I have connected to the PC USB Port and the USB Port on the printer. However the message appears connection failure. I have re installed the printer hardware and selected printer software Win98 with no success.I have tried COM1 to no avail. Can anyone assist please? Pam -- Pam |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adapters for USB ports | [email protected] | General | 2 | March 4th 05 07:47 PM |
COM ports and DOS programs | Jacob | General | 5 | January 17th 05 07:43 PM |
Wireless Broadband - Opening Ports? | Shannon | Networking | 3 | September 21st 04 08:40 AM |
usb ports do not work. | Setup & Installation | 0 | June 27th 04 02:52 AM | |
conflict i/o ports : 2f8 | Steven Aspinall | General | 15 | June 16th 04 09:59 PM |