|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 28th 10, 03:11 AM
posted to microsoft.public.win98.gen_discussion
|
|||
|
|||
Boot Sequence
I have an older computer that has XP that Installed however it freezes once I
click on the desktop. I have done every test imaginable, so I got out an old HD that has windows 98 on it and that one loaded fine with no freezing. Before I make a decision that it was the other HD, I want to test the RAM; however I have to change the boot sequence to floppy drive and I cannot remember the F key to get to the book sequence since it has been years since I have used Windows 98. Anyone Remember? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boot Sequence | sheila4typing | General | 21 | March 1st 10 07:58 AM |
| 98se reboots before finishing boot sequence. | John | General | 8 | January 29th 06 04:46 PM |
| How to set boot sequence on IBM 300PL | charles bridges | Setup & Installation | 19 | October 24th 05 09:23 PM |
| Boot Sequence | Sean | Setup & Installation | 1 | October 12th 05 09:08 PM |
| Boot Sequence | Charles Richardson | General | 3 | August 20th 04 07:59 PM |
Linear Mode
