If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Won't Read Printer on USB
My sister has win98. She disconnected her computer and set it up in the new
house. the computer will not read the printer, it worked fine at the old location. i was looking for a way to discunnect the USB port (like in the remove hardware in winXP) and plug in the printer again. i have tried unplugging and replugging already Theresa |
#2
|
|||
|
|||
" wrote in message ... My sister has win98. She disconnected her computer and set it up in the new house. the computer will not read the printer, it worked fine at the old location. i was looking for a way to discunnect the USB port (like in the remove hardware in winXP) and plug in the printer again. i have tried unplugging and replugging already Theresa startsettingsprinters...remove printer....reboot , then try again |
#3
|
|||
|
|||
"
wrote in message ... My sister has win98. She disconnected her computer and set it up in the new house. the computer will not read the printer, it worked fine at the old location. i was looking for a way to discunnect the USB port (like in the remove hardware in winXP) and plug in the printer again. i have tried unplugging and replugging already Theresa Check the printer is powered up!!! Double check the cable is fully plugged in at BOTH ends. Connect to the same USB port in the PC as before. Try it with all the other USB ports. If you still don't have any luck, THEN uninstall as suggested by Haggis. Simon |
#4
|
|||
|
|||
"
wrote in message ... My sister has win98. She disconnected her computer and set it up in the new house. the computer will not read the printer, it worked fine at the old location. i was looking for a way to discunnect the USB port (like in the remove hardware in winXP) and plug in the printer again. i have tried unplugging and replugging already Theresa One further suggestion before you uninstall: Try a different cable if you can. Its possible the original was damaged if everything has been packed up. Simon |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Computer does not "see" printer | John | General | 8 | October 22nd 04 03:56 PM |
port problems? | solo_senorita | Printing | 3 | July 25th 04 03:54 AM |
printer driver | Chuck | Printing | 0 | June 12th 04 10:02 PM |
How do I print to TCPIP connected printer from Win98? | Al Dykes | Networking | 0 | June 6th 04 04:13 PM |
share a printer on WIN98 | Blair | Networking | 5 | June 1st 04 05:43 PM |