|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 18th 05, 09:29 PM
|
|||
|
|||
How to set boot sequence on IBM 300PL
Can someone tell me how to set the boot sequence on an IBM 300PL running
windows 98SE. It has 2 hard drives and is trying to boot to the one that has nothing on it. I can unplug it and it will boot up and work on the other one. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tech student back again with question regarding boot sequence.. | YvonneM | General | 9 | May 4th 05 10:45 AM |
| Whoa. What was that? 98 load failure and.... | keith | General | 20 | March 3rd 05 06:46 AM |
| error message | bill | General | 7 | August 10th 04 02:09 AM |
| No Info in Cofig.sys or Autoexec. | Ralph Jaggi | General | 84 | July 19th 04 09:44 PM |
| MBR switch on FDISK | jt3 | General | 30 | June 21st 04 08:56 PM |
Threaded Mode