If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DNS settings.
If this is inappropriate for this NG
please advise a suitable group. I wish to employ open dns. 2 queries: 1: in config, I have "obtain IP addresses automatically" (no dns number shown) My D link router (DL524) is not shown. Can I carry on regardless and use DL624 and given dns numbers ? also I show 2 sets of ethernet NIC's I assume I put the numbers in both? |
#2
|
|||
|
|||
DNS settings.
"Rod" wrote in message
... If this is inappropriate for this NG please advise a suitable group. I got good advice in microsft.public.win98.networking. -- Don Phillipson Carlsbad Springs (Ottawa, Canada) |
#3
|
|||
|
|||
DNS settings.
"Don Phillipson" wrote in message If this is inappropriate for this NG please advise a suitable group. I got good advice in microsft.public.win98.networking. Don Phillipson Thanks Don, I'll shimmy over there |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
bios settings or settings | mostwantedplumber | Setup & Installation | 2 | April 14th 06 02:11 AM |
IE Settings | Mav | General | 2 | May 20th 05 01:55 PM |
TCP/IP Settings | IainGarrow | Networking | 2 | May 7th 05 11:03 PM |
Settings | C | Software & Applications | 1 | September 18th 04 07:56 AM |
DMA settings | Terry Cano | General | 2 | September 13th 04 06:32 AM |