|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 9th 04, 01:37 AM
|
|||
|
|||
floppy drive problem
My Win98SE can no longer access the A: Drive floppy disk.
I have replaced the ribbon cable, used two new (refurb) Teac drives from Dell parts, deleted the controller and redetected it and still the same problem. The drive whirrs went I try to access it thru Windows Explorer and I get the following message "A:\ is not accessible. The device is not ready" If I attempt to use the Send to: Floppy command; I get the whirring sound and the following message "There is no disk in drive A. Insert a disk and try again." Device manager says both the controller and Generic floppy disk are working properly with no conflicts. Help please from anyone with a similar situation. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem in Windows 98SE after changing hard drive. | Stan Hilliard | General | 36 | August 3rd 04 05:14 AM |
| Error - "CD Rom drive is not accessible; the device is not ready." | J Eklund J.D. | Multimedia | 0 | July 14th 04 07:21 AM |
| Error - "CD Rom drive is not accessible; the device is not ready." | J Eklund J.D. | Multimedia | 0 | July 14th 04 07:21 AM |
| Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |
| Recognizing USB F: floppy drive | Anders | Disk Drives | 0 | May 7th 04 03:39 PM |
Threaded Mode