If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
COnfiguring Network Printer
Running a Win2000 Server with 5 nodes( all running win98 SE). On all
but one of the nodes I can install and configure printers with a pseudo LPT port(LPT2 or LPT3), even through this port do not exist. These are network printers and I can prepend the LPT3 to the beginning of the network address, such as: LPT3: (//hq1/oki321). This allows the accounting software that we use to utilize the printers. I cannot do this on one of the PC's, error message - port does not exist. If anyone has any ideas about how to perform this on the remaining computer, I would be most greatful. Thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help me set up network printer? | [email protected] | Improving Performance | 1 | August 19th 04 03:44 PM |
Local Printer Conflict With Network Printers << Help Needed ! | Cobus Bonthuys | Printing | 0 | July 7th 04 05:07 PM |
printer driver | Chuck | Printing | 0 | June 12th 04 10:02 PM |
How do I print to TCPIP connected printer from Win98? | Al Dykes | Networking | 0 | June 6th 04 04:13 PM |
share a printer on WIN98 | Blair | Networking | 5 | June 1st 04 05:43 PM |