|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 15th 04, 04:22 AM
|
|||
|
|||
HP 842C reboots when printing
I just added DSL and now the HP 842C printer
reboots my machine about half the time. I already had ethernet card configured but it was rarely used. I downloaded and reinstalled the print driver and the HW config says it is fine. It prints fine from my laptop USB. I tried RAW instead of EMF mode, no difference. I have been using this printer for a year OK. Each reboot (scandisk of course) takes awhile so trying many things is time consuming... Quite a stumper?!? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two-Sided Printing | Lavert | General | 2 | July 11th 04 08:32 PM |
| printing web page | Jason | Internet | 0 | July 7th 04 06:32 PM |
| win98 clients all have printing problems in morning | Matt | Printing | 1 | June 30th 04 06:00 PM |
| computer reboots before it get to the operating system | Brian | Setup & Installation | 0 | June 27th 04 09:15 PM |
| Visual Basic printing problem | dhiman | Software & Applications | 3 | June 25th 04 03:29 PM |
Threaded Mode