If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Slave wont connect to ISP
I used internet connection wizard to connect my slave HD
to my ISP. All the numbers have been checked but it does'nt connect just says 'The computer you dialled did not answer' The master HD is fine and connects no problem. |
#2
|
|||
|
|||
OK stand by I recieved an email from my ISP with instructions........... |
#3
|
|||
|
|||
[...]
W'll....then send him to bed without any supper.... Jan |
#4
|
|||
|
|||
No it's still no good, I don't know why I can connect with the master HD but not with the slave. I put in all the right numbers. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem recognising 2nd HD set as slave | James Williams | Disk Drives | 10 | September 24th 04 04:35 PM |
Win98 laptop can't connect to the internet - Help!! | BF | Networking | 2 | August 30th 04 05:33 AM |
reinstalling 98 after format on a slave drive | Donna | Setup & Installation | 5 | August 24th 04 09:49 PM |
Long Wait-Time to Connect to Internet ? | James Nipper | General | 3 | August 16th 04 03:18 PM |
Slave HD. | 98 Slave | General | 4 | July 21st 04 11:03 PM |