|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 15th 05, 07:09 PM
|
|||
|
|||
Please advise on new RAM module placement
My brother, is using a Compaq Prosignia Desktop 320, with a 64 MB
SDRAM PC100 - 100MHz 168 pin DIMM memory module. The mainboard's (Intel B1440ZX) memory maximum is 256 MB. We recently ordered an additonal 128 MB RAM module from Crucial.com. MAke sure that the new RAM is not DDR. The mainboard has two RAM slots (1 and 2): Slot 1 = 64 MB Slot 2 = 128 MB I have never found it to matter where it's placed(and I've done a lot of RAM switching). Yes, PC100 RAM too. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| installing used RAM module in old machine | Larry | General | 13 | June 21st 05 01:36 PM |
| access violation in module kernel32 | anthony | Software & Applications | 2 | October 7th 04 02:27 PM |
| explorer invalid page fault module kernel32.dll | andy | General | 4 | October 6th 04 10:43 PM |
| unknown? | genX | Software & Applications | 4 | July 11th 04 01:36 PM |
| Please: Internet connection severed by "invalid page fault in module MSJAVA. DL | martha | Improving Performance | 3 | May 24th 04 02:34 AM |
Threaded Mode