If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Blank screen
A workmate attempted to upgrade a friends compaq presario from ME to XP,after
he had finished, the monitor display would not come on, the active light on the monitor flashed on for about 3 seconds then went back to standby. I have visited the Compaq website and attempted to reset the BIOS using their instructions but to no avail, attempting to get into safe mode is no good either, no display. The original ME operating system is is stored on the hard drive, so no access to that either. Any suggestions? John |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blank screen with full screen dos window | SlackerAPM | General | 5 | August 7th 06 10:30 PM |
Blank Screen | Summer | General | 7 | May 7th 05 02:00 AM |
Blank Screen | James Orr | General | 2 | September 28th 04 02:52 PM |
Computer gets to logo screen & then blank screen with blinking cursor | Bill Hopkins | General | 0 | September 2nd 04 09:05 PM |
Blank screen | Crystal | General | 3 | July 14th 04 10:21 AM |