If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3C9x NIC syntax for setting to 100 full Ghost
I am using Symantec Solution Suite 1.1 Ghost and have not been able to
find the correct syntax for setting the modifications in the Ghost boot wizard to make disc 100 full. Our network is Cisco switched and ghost flies at about 500 to 600 mg but the 3C90x auto nogotiages at 10 half and go painfully slow. Can someone help. Symantec support was no help and 3com's site offered no help for DOS syntax. |
#2
|
|||
|
|||
3C9x NIC syntax for setting to 100 full Ghost
can you turn off the auto negotiate in the NIC properties?
you should be able to set it at 100 full by default ..then you wouldn't need the command line... "Dick" wrote in message ups.com... I am using Symantec Solution Suite 1.1 Ghost and have not been able to find the correct syntax for setting the modifications in the Ghost boot wizard to make disc 100 full. Our network is Cisco switched and ghost flies at about 500 to 600 mg but the 3C90x auto nogotiages at 10 half and go painfully slow. Can someone help. Symantec support was no help and 3com's site offered no help for DOS syntax. |
#3
|
|||
|
|||
3C9x NIC syntax for setting to 100 full Ghost
can you turn off the auto negotiate in the NIC properties?
you should be able to set it at 100 full by default ..then you wouldn't need the command line... "Dick" wrote in message ups.com... I am using Symantec Solution Suite 1.1 Ghost and have not been able to find the correct syntax for setting the modifications in the Ghost boot wizard to make disc 100 full. Our network is Cisco switched and ghost flies at about 500 to 600 mg but the 3C90x auto nogotiages at 10 half and go painfully slow. Can someone help. Symantec support was no help and 3com's site offered no help for DOS syntax. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How - Start DOS application Full Screen on startup? | shtuks | Software & Applications | 1 | October 1st 06 12:48 AM |
How - Start DOS application Full Screen on startup? | shtuks | General | 3 | September 14th 06 11:10 PM |