If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Secondary IDE controller problem
Running Win98 on a PIII 450 with 64 MB RAM, I cannot see the CD drive.
This is strange for many reasons, not least of which. I installed the OS from a CD! The CD drive is visible to the BIOS, and works well if I boot to DOS with the Win98 floppy. In Windows there is a problem with the Secondary IDE controller (dual fifo) – “The device is either not present, not working properly or does not have all the drivers installed (Code 10)�. I tried updating the driver, but Windows reported that it already had the best one. I tried deleting the whole Intel 82371AB/EB PCI Bus Master IDE Controller (from device manager) and rebooting, and both primary IDE and secondary IDE controllers seemed to reinstall properly, but the problem was still there. To pre-empt a question, I am using the Secondary IDE controller because the computer case is so badly designed I cannot get the CD drive on the same cable as the hard drive. I’d be grateful for any thoughts or advice on this one. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Device Manager Problem | cpojano | General | 9 | October 6th 05 07:25 AM |
Disk controller not loading, hard drive not seen | PeteV | Disk Drives | 9 | September 27th 05 12:45 AM |
Boot | KB | General | 8 | May 15th 05 11:39 PM |
IDE Controller Issue-Software or Hardware Problem? | Tom Young | General | 1 | September 1st 04 05:21 AM |
Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |