If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
no client or protocals loading
windows ME
net card loads OK but hangs on client or protocal when added in network properties it has them to select but won't load them. help |
#2
|
|||
|
|||
"netguy007" wrote in message ... windows ME net card loads OK but hangs on client or protocal when added in network properties it has them to select but won't load them. help try booting to safe mode and seeing if you have multiple entries in device manager for your nic ...remove 'all' entries , reboot and try again |
#3
|
|||
|
|||
no client or protocals loading
"netguy007" wrote in message ... windows ME net card loads OK but hangs on client or protocal when added in network properties it has them to select but won't load them. help try booting to safe mode and seeing if you have multiple entries in device manager for your nic ...remove 'all' entries , reboot and try again |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MPREXE caused a general protection fault in module KERNEL32.dll at | William, the Novice | General | 4 | February 7th 05 03:45 PM |
Big problem--Please help | Mark | General | 15 | February 6th 05 04:24 AM |
Createing Install routines for client server apps | DS | Networking | 0 | October 14th 04 01:46 PM |
ICS. Host freezes when client requests web address | Community_Tech | General | 1 | September 20th 04 03:14 PM |
can't get client for microsoft networks on bootup | Ev | Networking | 1 | July 7th 04 12:32 AM |