If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Network Printer port resets on boot up
I have an HP 1210 PSC printer attached to my desktop Pc running XP and shared
via network with my laptop running Windows 98. After setting the appropriate port the laptop prints to the printer just fine. However, whenever I re-boot the laptop, the port settings for the network print are changed on bootup. I must then reset the printer port on the laptop in order to print again. How can I prevent the port settings from changing every time the laptop is re-booted? Thanks, Lou |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lexmark z515 printer doesn't see USB port | j smith | General | 8 | November 11th 04 05:53 AM |
Please help! Display settings !! | Mitzi | Monitors & Displays | 12 | July 11th 04 05:19 AM |
Local Printer Conflict With Network Printers << Help Needed ! | Cobus Bonthuys | Printing | 0 | July 7th 04 05:07 PM |
How do I print to TCPIP connected printer from Win98? | Al Dykes | Networking | 0 | June 6th 04 04:13 PM |
share a printer on WIN98 | Blair | Networking | 5 | June 1st 04 05:43 PM |