If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dark screen on a couple NEC AccuSync 50 monitors. Is there a way to restore factory settings?
Dark screen on a couple NEC AccuSync 50 monitors. Is there a way to
restore factory settings? I've seen this problem on a couple monitors. The user can press the Select button and change the screen so dark you can't see built-in menus to adjust the picture! Then the monitor seems to memorize the setting. Is there some way to override this? Unplugging & disconnecting didn't seem to do it. |
#2
|
|||
|
|||
Some but not all NEC monitors have a reset button on them, otherwise removing
power for a set amount of time and restoring power is the only way I know of. Have you tried NEC's support site or contacting them? -- Brian A. Sesko { MS MVP_Shell/User } Conflicts start where information lacks. http://www.dts-l.org/goodpost.htm http://basconotw.mvps.org/ "Nate Goulet" wrote in message ... Dark screen on a couple NEC AccuSync 50 monitors. Is there a way to restore factory settings? I've seen this problem on a couple monitors. The user can press the Select button and change the screen so dark you can't see built-in menus to adjust the picture! Then the monitor seems to memorize the setting. Is there some way to override this? Unplugging & disconnecting didn't seem to do it. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Windows logon screen | ms | Setup & Installation | 10 | May 19th 05 01:32 PM |
Help: Boot Screen Info | Darren Harris | General | 12 | July 27th 04 11:27 PM |