|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 17th 04, 01:54 PM
|
|||
|
|||
Settings
I can't get my settings changed on my PC with Windows ME.
I go in and change them (color and screen area/pixel) and I get a prompt to restart to change settings but when it comes back up it's back to the same. Any suggestions? Thanks! C 
|
|
#2
September 18th 04, 07:56 AM
|
|||
|
|||
|
Sounds like your drivers may be slightly corrupted.
Reboot to Safe Mode Open Device Manager Remove ALL Display Adapters Remove ALL Monitors Reboot to Normal Mode - Windows will reinstall the required drivers - hopefully curing your problem. -- Noel Paton (MS-MVP 2002-2004, Win9x) Nil Carborundum Illegitemi http://www.btinternet.com/~winnoel/millsrpch.htm http://tinyurl.com/6oztj Please read http://dts-l.org/goodpost.htm on how to post messages to NG's "C" wrote in message ... I can't get my settings changed on my PC with Windows ME. I go in and change them (color and screen area/pixel) and I get a prompt to restart to change settings but when it comes back up it's back to the same. Any suggestions? Thanks! C
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Importing (some) settings from 98 to fresh install of 98SE | Michele Dondi | General | 11 | July 24th 04 08:42 PM |
| Importing (some) settings from 98 to fresh install of 98SE | Michele Dondi | Setup & Installation | 11 | July 24th 04 08:42 PM |
| ActiveX settings | Wade Koehn | Monitors & Displays | 0 | July 21st 04 04:54 PM |
| lan settings | joe | Networking | 1 | June 25th 04 10:50 AM |
| Put Documents and Settings on D partition? | Clark G | General | 1 | June 11th 04 06:01 AM |
Linear Mode
