If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DISPLAY.SYS.
When I start my computer it comes up with the message
cannot set the code page(s)in DISPLAY.SYS. But if i wait a minute after the message windows me loads up normally but if I dont wait a minute and reboot, the computer gives me the option to load up in start mode etc. I have loaded up in start mode and I still cannot figure out what the problem is. Can anyone help please. |
#2
|
|||
|
|||
DISPLAY.SYS.
This problem may be due to a misconfigured environment setting - try this
Start|Run type MSCONFIG click OK click on the International tab - and look there for entries. try using the dropdown to set your location properly, and click OK Reboot on request, and see if that helps. -- Noel Paton (MS-MVP 2002-2004, Win9x) Nil Carborundum Illegitemi http://www.btinternet.com/~winnoel/millsrpch.htm http://tinyurl.com/6oztj Please read http://dts-l.org/goodpost.htm on how to post messages to NG's "Sarah" wrote in message ... When I start my computer it comes up with the message cannot set the code page(s)in DISPLAY.SYS. But if i wait a minute after the message windows me loads up normally but if I dont wait a minute and reboot, the computer gives me the option to load up in start mode etc. I have loaded up in start mode and I still cannot figure out what the problem is. Can anyone help please. |
Thread Tools | |
Display Modes | |
|
|