|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 16th 06, 12:51 AM
posted to microsoft.public.win98.disks.general
|
|||
|
|||
Scandisk won't run on USB drive
Scandisk tells me I don't have enough memory to run when I try to check a USB drive.
It works OK when I check the internal drives. Rebooting and running Scandisk first does not help. The USB drive has 105GB used and 80GB free. Windows crashed while it was writing to the drive and now I get an error telling me the drive is full when I try to add any more files to it. I can read the existing files just fine. I figure I need to run Scandisk. Is this right? Any suggestions on how to proceed? I'm running Win98SE 4.10 with 640MB RAM. Thanks in advance for any assistance Oscar 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tosh Satellite Bios gone bye bye? | bry | General | 18 | March 7th 06 09:55 PM |
| registry problem. | Mark Garron | General | 13 | May 18th 05 03:38 PM |
| WIN98SE BOOT PROBLEM | R.L. Barnhart | Disk Drives | 2 | May 12th 05 10:25 PM |
| installing new hard driive, copying from old to new | Larry | General | 12 | February 17th 05 08:20 PM |
| Using scandisk on hard drive | Wayne | General | 5 | January 6th 05 05:23 PM |
Threaded Mode