If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Any Tapi/Dun/Modem Experts Question
On Tue, 25 Oct 2005 01:00:36 +0000 (UTC), nonewbie
put finger to keyboard and composed: cannot get dun to work with aztech mdp3880-w(u) modem. installed latest drivers, install went fine. "more info" reported info from the modem. When I try to dialout using dun i get : "error 633- modem is not installed or configured for dialup, double click on the modems icon in control panel" When I do the above, it tries to reinstall the modem drivers,even though they have already been installed. Tried on of MS's solutions and rebuilt telephon.ini, still no go. Also did their registry fix for telephon.ini tried uninstalling and reinstalling drivers and modem still no problem. Modem now assigned to com3 IRQ 10 in my Dell dimension bios, there is a section for all the irqs where u set it to either available or reserved, but I was told that this is only for non-plug and pray modems and I got a message from windows saying this is plug and pray modem. IRQ is currently marked available in bios. Your modem uses a Rockwell/Conexant HCF (controllerless) chipset. It's not a bad performer, at the very least it uses much less CPU power than Conexant's softmodems (HSF). These are Conexant's generic drivers for HCF modems: http://www.conexant.com/support/files/HCFp_Win9x.zip This is the entry point for all other drivers: http://www.conexant.com/support/md_d...ssistance.html Your modem's properties, commands, and responses are located at this registry key: HKEY_LOCAL_MACHINE\System\CurrentControlSet\Servic es\Class\Modem\000n How does yours look? If this key has a problem, then check the contents of the modem's INF file. That's where the setup info comes from. Can you set up a comms session using HyperTerminal? Here is a FAQ that may have useful info: http://www.conexant.com/support/md_faqs.html IIRC, there is a special procedure to uninstall HCF/HSF drivers. Here is an excerpt from the FAQ: ================================================== =================== I would like information on drivers to install for both modem enumerator and modem. The installation instructions are packaged with the generic drivers. Please refer to the readme.txt file for instructions on how to remove and install the drivers. ================================================== =================== Here are two other sites that may be useful: http://www.aztech.com.sg/SAnalog.htm#14 http://www.modemsite.com/56k/rockhcf.asp -- Franc Zabkar Please remove one 'i' from my address when replying by email. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Any Tapi/Dun/Modem Experts Question | jt3 | General | 9 | November 2nd 05 12:38 AM |
Any Tapi/Dun/Modem Experts Question | Ben Myers | General | 2 | October 31st 05 01:06 PM |
Any Tapi/Dun/Modem Experts Question | glee | General | 7 | October 31st 05 03:35 AM |
Any Tapi/Dun/Modem Experts Question | poatt | General | 1 | October 28th 05 06:26 PM |
Poledit question | JohnDeeze | General | 0 | December 6th 04 01:35 AM |