If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Reading Autoexec.bat
Hi,
I have installed some applications that require settings be made in the autoexec.bat file. I have made the necessary entries, but the autoexec.bat file doesn't seem to be read when booting up. ie: From a DOS prompt I should be able to invoke various applications that have been referred to in the autoexec.bat file - however only a message BAD COMMAND OR FILE NAME is displayed, as if nothing exists? Any ideas? Dingus. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dr seuss reading games | laura justen | General | 1 | August 18th 04 10:39 PM |
Autoexec.bat | Sandrobi | General | 2 | August 17th 04 07:29 PM |
Major errors in config.sys & Autoexec.bat | Kim | Setup & Installation | 4 | August 2nd 04 02:23 AM |
Scandisk data error while reading cluster 419202 | N Dias | Disk Drives | 1 | July 8th 04 03:52 PM |
I'm unable to access the Yes No boxes after reading the user agreement for Win M | [email protected] | Setup & Installation | 1 | June 1st 04 09:51 PM |