|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 10th 07, 11:32 PM
posted to microsoft.public.windowsme.general
|
|||
|
|||
Windows Millenium on 2 GB USB Stick
I've successfully installed Windows Millenium on my 2 GB Patriot USB
Stick, but I've got only one problem. When I install drivers to my VIA 8235 integrated USB 2.0 Controller I've got a blue screen with "disk write error". I knew that system probably must disconnect all devices currently connected to the USB ports. I've got also a 64 MB flash disk installed on first IDE port in my PC. Is there any possibility to change the location of system drivers, so it could disconnect USB devices until installation of USB controller drivers is complete ? 
|
|
#2
February 10th 07, 11:34 PM
posted to microsoft.public.windowsme.general
|
|||
|
|||
|
Windows Millenium on 2 GB USB Stick
My USB Stick operates now at USB 1.1 mode so I can only use it with
speed of at about 2 Mbps 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with additional RAM aand NIC | Alan | General | 25 | September 2nd 06 09:36 PM |
| Problems with additional RAM aand NIC | Alan | Setup & Installation | 25 | September 2nd 06 09:36 PM |
| Other or alternative Windows Updates | MEB | General | 3 | March 4th 06 04:20 AM |
| Win98SE constant problems-ole32,shell32,other | MEB | General | 14 | January 15th 06 04:39 AM |
| SCANDISK on 6GB drive producing Errors at 2.09GB to end. | Jerry | Disk Drives | 15 | July 21st 05 07:00 PM |
Linear Mode
